Posted: Thursday May 6th, 2010 09:00 pm |
|
1st Post |
Ingo
UCM Pi Users
Joined: | Sunday Jan 21st, 2007 |
Location: | South Africa |
Posts: | 560 |
Status: |
Offline
|
back to top
|
I was wondering if the CBus 'Measurement Application' is supported, it's application 228 ($E4).
Can I send the following command to my UCM/Cbus: 197,18,1,2,20,228,255
I am trying to send a value of 20 to the CBus side on application 228. Once I get that right then maybe I can use the Measurement Application to read the values sent from Comfort.
Ingo.
|
Posted: Friday May 7th, 2010 12:57 am |
|
2nd Post |
admin
Administrator
Joined: | Saturday Mar 3rd, 2007 |
Location: | Singapore |
Posts: | 1200 |
Status: |
Offline
|
back to top
|
Yes you can send a message to any application in C-Bus
That series of codes is equivalent to Cbus RampInst 2 1 20 228, ie Instantaneuous Ramp to level 20 on Group address 1 for Applocation 228
|
Posted: Friday May 7th, 2010 12:57 am |
|
3rd Post |
admin
Administrator
Joined: | Saturday Mar 3rd, 2007 |
Location: | Singapore |
Posts: | 1200 |
Status: |
Offline
|
back to top
|
Yes you can send a message to any application in C-Bus
That series of codes is equivalent to Cbus RampInst 2 1 20 228, ie Instantaneuous Ramp to level 20 on Group address 1 for Applocation 228
|
Posted: Friday May 7th, 2010 07:18 am |
|
4th Post |
Posted: Friday May 7th, 2010 09:28 am |
|
5th Post |
admin
Administrator
Joined: | Saturday Mar 3rd, 2007 |
Location: | Singapore |
Posts: | 1200 |
Status: |
Offline
|
back to top
|
The Response wizard does not support this. They did not have these details when the UCM/Cbbus was developed
What is your application?
|
Posted: Friday May 7th, 2010 03:52 pm |
|
6th Post |
Ingo
UCM Pi Users
Joined: | Sunday Jan 21st, 2007 |
Location: | South Africa |
Posts: | 560 |
Status: |
Offline
|
back to top
|
Thanks for the update, I will wait for a future firmware update that might support this application then.
Regards,
Ingo
|
|