The main panel was fitted in 2001, which uses a microswitch and worjs fine.
the sep was fitted in 2009 and uses a round plastic plunger switch. It came with a spare switch, which I tested too and that acts the same.
no false alarms today so I am hoping that is it, fingers crossed !
I am now thinking it could be time to upgrade to a comfort 2 pcb. Is there a comfort 3 in the pipeline ? (If there is I will wait for it, I've waited this long)
Thanks. No tamper yesterday, yay !!
Fingers crossed it's fixed.
I'm thinking of upgrading the pcb and Ethernet ucm so I can use the comfort apps, and get away from serial port for configurator.
If the main pcb is about to be revised then I would wait (eg I saw the discussion regarding dropping x10 in favour of Ethernet). I still use x10 for remote control of garden lights, so hope it doesn't get dropped...
I will send a message to determine cost and where to buy the upgrade should I decide to proceed.